set_id
Differences
This shows you the differences between two versions of the page.
set_id [2016/01/26 01:26] – created k0kad | set_id [2016/01/26 04:15] (current) – Page Reformat k0kad | ||
---|---|---|---|
Line 6: | Line 6: | ||
pico / | pico / | ||
- | You can also edit this file from the IRLP Remote | + | You can also edit this file from the IRLP Remote |
- | min system. | + | The variables which can be edited include: |
- | The variables which can be edited include: | + | |
- | USE_INTERVAL_ID | + | |
- | - Turns the ID system ON or OFF (YES or NO) | + | |
- | VOICE_ID_FILE | + | |
- | - Voice ID wav file that is played if it exists. To | + | |
- | make the system play the | + | |
- | voice ID file, just place the selected file onto th | + | |
- | e node. | + | |
- | ID_PTT | + | |
- | - Selects whether the PTT or AUX1 is used as a keyi | + | |
- | ng pin. For PiRLP this | + | |
- | should be kept as AUX1. | + | |
- | ID_INTERVAL | + | |
- | - Required ID interval in seconds (10 min = 600) | + | |
- | ID_MIX | + | |
- | - Mixes the ID with regular node audio. For PiRLP n | + | |
- | odes this should be set | + | |
- | to YES. | + | |
- | MORSE_TEXT | + | |
- | - The morse text that is played for the ID. By defa | + | |
- | ult this is set to the | + | |
- | callsign defined earlier in the file. Be sure to en | + | |
- | close the text you want | + | |
- | played in quotes. | + | |
- | MORSE_SPEED | + | |
- | - Options are SLOW (5wpm), MEDIUM (8wpm), FAST (15w | + | |
- | pm), | + | |
- | FASTEST (30wpm) | + | |
- | MORSE_PITCH | + | |
- | - Frequency in Hz that the morse is played at (300- | + | |
- | 3000) | + | |
- | MORSE_VOLUME | + | |
- | - % volume that the morse is played at (1-100) | + |
set_id.txt · Last modified: 2016/01/26 04:15 by k0kad