installing_pirlp
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
installing_pirlp [2016/01/26 00:53] – [Hardware Modifications Required] k0kad | installing_pirlp [2016/01/26 05:29] (current) – [Prerequisites and Disclaimer] k0kad | ||
---|---|---|---|
Line 5: | Line 5: | ||
If you would like a ready-built and configured system, consider ordering one | If you would like a ready-built and configured system, consider ordering one | ||
- | direct from IRLP at http://www.irlp.net/pi/ | + | direct from IRLP at http:// |
+ | and all necessary parts to complete your PiRLP project. | ||
---- | ---- | ||
Line 15: | Line 16: | ||
Second thing - This is experimental and not supported. If it breaks something, | Second thing - This is experimental and not supported. If it breaks something, | ||
- | the IRLP installs team can try to help, but we can not forsee | + | the IRLP installs team can try to help, but we can not foresee |
IRLP will try to help where I can, but can not promise it will all work. If you | IRLP will try to help where I can, but can not promise it will all work. If you | ||
are not able to troubleshoot the problem on your own, consider ordering a complete | are not able to troubleshoot the problem on your own, consider ordering a complete | ||
- | built and configured PiRLP node from the IRLP website: http://www.irlp.net/pi/ | + | built and configured PiRLP node from the IRLP website: http:// |
====Hardware Required==== | ====Hardware Required==== | ||
Line 64: | Line 65: | ||
http:// | http:// | ||
- | If you are using a Pi2 or Pi B+ with a 40 pin header, you must cut pins 27 and 28 from the board in order to fit the GPIO cable on. | + | If you are using a Pi2 or Pi B+ with a 40 pin header, you must cut pins 27 and 28 from the board in order to fit the GPIO cable on. |
- | See: [[http:// | + | See: [[http:// |
- | It also shows pin 4 removed - this is not required. It is used as a key for systems ordered from IRLP. | + | It also shows pin 4 removed - this is not required. It is used as a key for systems ordered from IRLP. |
====Loading the Required Software==== | ====Loading the Required Software==== | ||
- | You will require the official Raspbian release from the Raspberry Pi Foundation: | + | You will require the official Raspbian |
http:// | http:// | ||
(no support will be offered for this, besides what buttons to press) Follow the | (no support will be offered for this, besides what buttons to press) Follow the |
installing_pirlp.txt · Last modified: 2016/01/26 05:29 by k0kad