installing_pirlp
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
installing_pirlp [2016/01/26 00:53] – [Hardware Modifications Required] k0kad | installing_pirlp [2016/01/26 01:00] – [Loading the Required Software] k0kad | ||
---|---|---|---|
Line 64: | Line 64: | ||
http:// | http:// | ||
- | If you are using a Pi2 or Pi B+ with a 40 pin header, you must cut pins 27 and 28 from the board in order to fit the GPIO cable on. | + | If you are using a Pi2 or Pi B+ with a 40 pin header, you must cut pins 27 and 28 from the board in order to fit the GPIO cable on. |
- | See: [[http:// | + | See: [[http:// |
- | It also shows pin 4 removed - this is not required. It is used as a key for systems ordered from IRLP. | + | It also shows pin 4 removed - this is not required. It is used as a key for systems ordered from IRLP. |
====Loading the Required Software==== | ====Loading the Required Software==== | ||
- | You will require the official Raspbian release from the Raspberry Pi Foundation: | + | You will require the official Raspbian |
http:// | http:// | ||
(no support will be offered for this, besides what buttons to press) Follow the | (no support will be offered for this, besides what buttons to press) Follow the |
installing_pirlp.txt · Last modified: 2016/01/26 05:29 by k0kad